Skip to content
Volts

Power over Ethernet voltage

Power over Ethernet voltage depends on where the value applies. TI's cited Type 1 example gives a 44 V minimum static output at the power source. It lists 37 to 57 V static input at the powered device for power up to 13 W.

Source-specific reference

These values apply only to the stated model, profile and conditions. They are not universal operating limits or compatibility approval.

Document
TI TPS2373 SLUSCD1C, November 2018
Profile
Table 6, Type 1 static operation
Pse output min (V)
44
Pd static input (V)
37 to 57 V for power up to 13 W
Pd input power max (W)
13
Scope
Manufacturer comparison row, not the latest IEEE standard or a universal voltage for every Ethernet port.

PSE output and PD input are different endpoints

PSE means power sourcing equipment; PD means powered device. TI's TPS2373 datasheet separates these endpoints in its comparison of operational limits. The receiving-end range is not the source's output tolerance. Nor should a minimum source value be presented as a nominal voltage for every Ethernet port.

Keep the Type 1 power condition attached

The figures above come from the Type 1 row, including its static operating and power conditions. The same comparison treats other types separately. This page therefore leaves the category's nominal voltage and universal bounds unset. It does not turn the cited row into a complete summary of every PoE generation or operating phase.

A voltage range cannot establish interoperability

TI also describes detection and classification before normal powering. Voltage alone leaves those steps unresolved. Read the actual source and receiving-device specifications before interpreting a connection. This reference does not approve a passive injector, adapter, cable, or powered product. Electrical arithmetic tools can help interpret known values, but cannot certify a PoE link.

Sources

See also