Skip to content

Home wiring

Electrical load

Calculate single-phase VA from current and voltage, with an optional 80% factor.

Illustrative only: unadjusted current × voltage example gives 1800 VA at 120 V. This does not determine real watts, circuit capacity, or code compliance.

PowerLOAD
1800 VA

Illustrative apparent power

Show steps
Reference current
15 A
Volts
120 V
UL example condition
Not selected
Modeled current
15 A
  1. This is a single-phase arithmetic example. Apparent power is volts × current, measured in volt-amperes (VA).
  2. No 80% scenario is applied. This is only the entered current × voltage, not a circuit-capacity or equipment-suitability result.
  3. Apparent power = 15 A × 120 V = 1800 VA. Real watts also depend on power factor.

Estimate only. Check equipment labels and local code.

Apparent-power example

What this calculator shows

Choose a reference current and 120 or 240 volts. The basic result is current × voltage in volt-amperes (VA). It is not a measured load, a circuit capacity, or a recommendation. Real power in watts also depends on the equipment's power factor.

Optional UL example

UL Solutions' molded-case breaker guide describes an 80% current limit for normal operation lasting three hours or more unless the breaker is marked for 100% continuous use. This calculator's optional scenario assumes the breaker is not marked 100%; verify the exact breaker, required enclosure, product instructions, and local rules. UL's guidance is not a complete installation assessment or proof of code compliance.

Example table

These are arithmetic examples for the optional UL scenario only. They do not say a circuit or appliance can safely use the displayed power.

Reference currentVA at 120 VVA at 240 V
15 A 1440 2880
20 A 1920 3840
30 A 2880 5760
40 A 3840 7680
50 A 4800 9600
60 A 5760 11520

Related arithmetic

For current-to-power conversions with explicit AC/DC and power-factor assumptions, use amps to watts . To work from power back to current, use watts to amps . These conversions do not select installation wiring or protection.

Limitations

The second option is a conditional UL example, not a finding about your equipment. Check the exact breaker marking and enclosure.

This is a calculation aid, not a permit.

This result does not choose a circuit, breaker, fuse, or conductor. It does not assess installation conditions or code compliance.

Sources

  1. UL Solutions molded-case circuit-breaker marking and application guide. Accessed 2026-10-21.
  2. U.S. Department of Energy Fundamentals Handbook: Electrical Science, Volume 3. Accessed 2026-10-21.

Sources provide context for the stated formulas and conditional example; they do not determine your equipment's rating or local requirements.

Cite this page

Wattopedia Editorial Team. Electrical load. https://wattopedia.com/electrical-load-calculator . Updated 2026-11-15.