Skip to content

Voltage in Nigeria: NESIS Supply Definitions

Voltage in Nigeria is described in NESIS as 230 V phase-to-neutral and 400 V between phases, with a 50 Hz reference. Read the dated regulation scope.

Voltage
230 V phase-to-neutral; 400 V between phases in 2015 NESIS
Frequency
50 Hz system reference in 2015 NESIS
Sources accessed
2026-10-22

Distinguish the voltage reference points

The cited NESIS regulation describes standard AC voltage as 230 V between phase and neutral and 400 V between phases. Its supply section uses a 50 Hz frequency reference and discusses variation conditions separately. These are system definitions, not a measurement made at a customer's appliance.

Configurations are not interchangeable sockets

The document also distinguishes single-phase two-wire and three-phase four-wire supplies. Their voltage labels should remain attached to those arrangements. Nothing here directs you to identify conductors, alter a supply or select a higher-voltage connection for a device.

Read the document as a dated reference

This page attributes its figures to the 2015 regulation. It does not certify the current consolidated legal position or apply every installation provision in that document. Where supply quality or the actual service matters, obtain site-specific information from the responsible operator rather than treating nominal figures as a guarantee.

Not a design specification No wiring table, tolerance promise, plug classification or protective-device selection is reproduced. Installation and unresolved compatibility questions require qualified assessment.