Skip to content

How Many Watts Does a DVD Player Use?

How many watts does a dvd player use? VCE lists VCR 17 to 21 watts and DVD 20 to 25 watts as separate ranges. These are general examples from 2020, not ratings for your model.

Sourced appliance facts
SpecificationSource-listed value
Historic nameplate example: vcr: minimum (W)17
Historic nameplate example: vcr: maximum (W)21
Historic nameplate example: dvd: minimum (W)20
Historic nameplate example: dvd: maximum (W)25

Current at an assumed voltage

Calculated examples for single-phase AC at power factor 1, using current = watts ÷ volts. These are not product-rated currents and do not show that a heater or other appliance can use the assumed supply.

Conditional current examples, not product ratings
Example input (W)Assumed voltage (V)Calculated current (A)
201200.1667
251200.2083
202400.0833
252400.1042

Calculate running cost

Enter electrical input watts from your appliance label or measurement. The reference does not establish a single running wattage.

Hours, days and rate start with the running-cost calculator's example, not your usage or tariff. Replace them with your own values. The result is in US dollars.

The slash-separated source entry represents separate VCR and DVD ranges. Its lower VCR bound must not be used as the DVD minimum. A combined range would misstate what the publication prints. The source does not identify playback, standby, a front clock, or a named disc-player model as separate test conditions.

How many amps does a dvd player use

For illustration only, assume single-phase AC at a power factor of 1. At 120 volts, 20 watts is 0.1667 amps and 25 watts is 0.2083 amps. At 240 volts, 20 watts is 0.0833 amps and 25 watts is 0.1042 amps. These are conditional arithmetic examples, not measured currents or installation recommendations. Do not assume a supply voltage or power factor for your equipment. No circuit, breaker, conductor, receptacle, or backup-system selection follows from this example.

Questions this source cannot answer

If your question concerns the cost of watching a disc, define whether the observation includes only the player or the television and sound equipment as well. Record the period and state being measured. A complete entertainment-system reading is not a player-only measurement. Standby cost also needs an appropriate observation rather than an assumed playback wattage.

What to do with the nameplate

Use the exact player's label and instructions for its electrical input. Do not transfer VCR-specific figures to a DVD player, or use this reference to rate a streaming device. The current examples deliberately use only the DVD bounds and explicit hypothetical supply assumptions. They do not select a power strip, establish a connection allowance, or guarantee consumption for your equipment.

Sources

See also