Skip to content

Network Switch Wattage: TP-Link TL-SG108

Network switch wattage is model specific. TP-Link lists 3.3 W maximum power consumption for the TL-SG108 on its US page. That is a listed maximum, not an idle reading or a measured daily average.

Sourced appliance facts
SpecificationSource-listed value
Source model: modelTP-Link TL-SG108, US product page as accessed
Source model: listed maximum power consumption (W)3.3
Source model: adapter output v DC9
Source model: adapter output a0.6
Source model: power behaviorManufacturer says consumption adjusts according to link status and cable length; no corresponding wattage curve given.

Calculate running cost

Enter electrical input watts from your appliance label or measurement. The reference does not establish a single running wattage.

Hours, days and rate start with the running-cost calculator's example, not your usage or tariff. Replace them with your own values. The result is in US dollars.

Network switch wattage for the TL-SG108

The US TL-SG108 hardware table lists maximum power consumption of 3.3 W. This entry applies to the named desktop switch as listed, rather than every switch with a similar port layout. The row does not name a traffic test, active link count or measurement point. Keep those limits attached when using it as a reference.

The adapter output is a separate field

The same table identifies an external adapter with output of 9 V DC and 0.6 A. Those are adapter output specifications, not a measured input at the wall. Multiplying them would describe output capacity and would not replace the consumption row. The page also lists heat dissipation separately; it is not an extra electrical load to add.

Link conditions limit comparisons

TP-Link says its energy-saving behavior responds to link status and cable length. The page provides no wattage curve for those conditions, so the maximum cannot establish an idle value or a saving for a particular network. For a comparison, record the switch identity, connected links and cable arrangement alongside the observed power, rather than assuming a fixed amount per port.

Keep the network measurement boundary clear

If a meter covers the switch and its adapter, label the result that way and record the observation time. A wider network measurement needs its own device list. A PoE delivery budget on another switch describes power available to attached equipment; it does not establish that switch's own consumption. Use energy from the stated measurement boundary before applying an electricity tariff.

Sources

See also