Skip to content

Server Power Consumption: Synology DS224+ Example

Server power consumption depends on the hardware and job. Synology lists 14.69 W during access and 4.41 W during HDD hibernation for its DS224+ NAS. These are model-specific reference states. They are not minimum and maximum ratings for a home server.

Sourced appliance facts
SpecificationSource-listed value
Source model: modelSynology DiskStation DS224+
Source model: access (W)14.69
Source model: hdd hibernation (W)4.41
Source model: adapter capacity (W)60
Source model: test method: drive format inches3.5
Source model: test method: drive modelHAT5300-12T
Source model: test method: drive populationfully populated
Source model: test method: storageSynology Hybrid RAID where available; RAID 5 fallback in general method
Source model: test method: meterChroma Model 66205
Source model: test method: averaging period minutes1
Source model: test method: uptime workloadcontinuous SMB file transfers from a Windows client
Source model: test method: file size mb30
Source model: test method: hibernation stateall HDDs in low-power mode; device on standby

Calculate running cost

Enter electrical input watts from your appliance label or measurement. The reference does not establish a single running wattage.

Hours, days and rate start with the running-cost calculator's example, not your usage or tariff. Replace them with your own values. The result is in US dollars.

Watts

The DS224+ is a network storage example, not a stand-in for every server. Synology separates its measured consumption from the 60 W power-adapter rating. Its linked testing article describes continuous SMB transfers of 30 MB files from a Windows client for the uptime test. The hibernation test keeps the device on standby with all hard drives in a low-power state. Results are averaged over a minute using a Chroma 66205 meter. The published method specifies that devices compatible with 3.5-inch drives are fully populated with HAT5300-12T drives and use SHR storage where available. These method details describe Synology's test procedure, not a record of the drives installed in your NAS.

Amps

Neither the access wattage nor the adapter's watt rating is an input-current reading. Match the adapter to the NAS and check its input label. This reference does not give measured AC amps for the access test, and it does not establish current for a collection of servers on a shared outlet.

What this source cannot answer

Synology explicitly says the test figures are not consumption minima or maxima. They also do not tell you how much time your server spends transferring files or hibernating. For a home estimate, log energy while your usual backups and services run. Record the drives, storage setup, and enabled jobs, then compare similar periods. If measuring at a backup unit's input, identify any switch, router, or other load included in that reading before attributing it all to the NAS.

Nameplate

Confirm DS224+ on the enclosure and retain the matching adapter information. Keep the source's access and HDD-hibernation labels in any comparison. An adapter capacity figure belongs in a different column from an operating measurement, even when both use watts.

Sources

See also