Skip to content

How Many Watts Does a Clothes Iron Use?

How many watts does a clothes iron use? VCE lists 1,000 to 1,800 watts in its historic nameplate examples. These are general examples from 2020, not ratings for your model.

Sourced appliance facts
SpecificationSource-listed value
Historic nameplate example: minimum (W)1,000
Historic nameplate example: maximum (W)1,800

Current at an assumed voltage

Calculated examples for single-phase AC at power factor 1, using current = watts ÷ volts. These are not product-rated currents and do not show that a heater or other appliance can use the assumed supply.

Conditional current examples, not product ratings
Example input (W)Assumed voltage (V)Calculated current (A)
1,0001208.3333
1,0002404.1667
1,80012015
1,8002407.5

Calculate running cost

Enter electrical input watts from your appliance label or measurement. The reference does not establish a single running wattage.

Hours, days and rate start with the running-cost calculator's example, not your usage or tariff. Replace them with your own values. The result is in US dollars.

The clothes-iron bounds are not identified as dry-setting, steam-setting, travel-iron, or full-size-iron ratings. Those product and operating labels are absent from the source. Do not present a position within the range as evidence about one of those settings. A figure printed on the actual iron is a different, product-specific reference.

How many amps does a clothes iron use

For illustration only, assume single-phase AC at a power factor of 1. At 120 volts, 1,000 watts is 8.3333 amps and 1,800 watts is 15 amps. At 240 volts, 1,000 watts is 4.1667 amps and 1,800 watts is 7.5 amps. These are conditional arithmetic examples, not measured currents or installation recommendations. Do not assume a supply voltage or power factor for your equipment. No circuit, breaker, conductor, receptacle, or backup-system selection follows from this example.

Questions this source cannot answer

When asking what an ironing session costs, distinguish the session duration from measured electrical energy. Record the model and the settings used during the observation. An electricity meter must be suitable for the load and used according to its instructions. Your observation should state whether it includes only the iron or any other connected appliance.

What to do with the nameplate

A dryer with an overlapping wattage is still a different appliance. Its current, cycle data, or connection requirements cannot fill the gaps in an iron's documentation. Keep any conversion explicitly conditional on the iron's own input information. This category reference gives no permission to add another load to a shared circuit.

Sources

See also