Skip to content

Central Air Conditioner Wattage: Rated Input

Central air conditioner wattage needs an exact system and mode. Daikin lists 1.35 kW rated cooling input for FDYAN50AV1 with RZA50C2V1. That is 1,350 W at the stated rating point.

Sourced appliance facts
SpecificationSource-listed value
Source model: modelDaikin FDYAN50AV1 indoor unit with RZA50C2V1 outdoor unit, Australian inverter ducted single-phase pair
Source model: documentPCDUAU0126
Source model: rated cooling input (kW)1.35
Source model: rated cooling input (W)1,350
Source model: cooling capacity (kW)5
Source model: supplySingle phase, 220-240 V, 50 Hz
Source model: cooling rating conditions: indoor dry bulb c27
Source model: cooling rating conditions: indoor wet bulb c19
Source model: cooling rating conditions: outdoor dry bulb c35
Source model: cooling rating conditions: outdoor wet bulb c24
Source model: cooling rating conditions: rating methodAS/NZS 3823.1.2
Source model: conversion1.35 kW = 1,350 W, exact unit conversion of listed electrical input, not a new measurement or a calculation from capacity/current.

Calculate running cost

Enter electrical input watts from your appliance label or measurement. The reference does not establish a single running wattage.

Hours, days and rate start with the running-cost calculator's example, not your usage or tariff. Replace them with your own values. The result is in US dollars.

Central air conditioner wattage for a ducted system

Daikin's Australian ducted brochure pairs indoor unit FDYAN50AV1 with outdoor unit RZA50C2V1. The single-phase table lists rated cooling input of 1.35 kW, equal to 1,350 W. It separately lists cooling capacity of 5.0 kW. Capacity describes cooling delivered, while input describes the rated electrical power. Using the capacity figure as electrical demand would confuse these separate fields. This example applies to the named Australian pair.

Read the conditions below the table

The brochure gives cooling rating conditions of 27 C dry bulb and 19 C wet bulb indoors, with 35 C dry bulb and 24 C wet bulb outdoors. It identifies the rating method in the notes. These conditions matter when comparing a field observation with the published input. They do not establish a steady reading at every outdoor temperature, thermostat setting or duct arrangement.

Retain the full pair and supply variant

The table identifies a single-phase supply of 220-240 V at 50 Hz. Keep that regional supply and both full model names with the rating. A matching indoor name alone does not justify substituting an outdoor variant from another document. The same table has separate heating input and capacity entries; neither should be relabeled as cooling demand. Supply specifications do not by themselves establish operating watts or backup compatibility.

Use a system energy record for operating cost

The rated input is a comparison point, not a daily energy measurement or a startup trace. For an operating-cost estimate, identify the actual equipment included in the energy record and the period it covers. Keep any separately supplied equipment visible in that boundary. Use energy and the applicable price for that period instead of assuming the system runs at its rating without pause. This reference does not size circuits or generators.

Sources

See also